Honda outboard motor parts manual
0 Check the propeller, the shear pin, and the cotter a clash of kings audiobook 2014 12 11.rar pin to be sure they are secure and undamaged.
Reinstall the engine cover.0 Make sure you have the tool kit and spare parts with you (p.Loosen the wing nut to free the adjusting bolt.Fuel CAP vent knob.The information in this publication was in effect at the time of approval for printing.Optional parts 20 B The-sections required no changes from the BF9.9A/15A owners 3ds max italiano full crack 64 bit manual.Move the throttle lever to the start position.Remove the recoil starter by removing the three 6 mm nuts.The remote control lever should move smoothly and freely.Keep the owners manual and this supplement handy, so you can refer to them at any time, and be sure they accompany the outboard motor if you sell.
0 Never permit anyone to operate the outboard motor without proper instruction.Pull the starter rope slowly until resistance is felt, then pull briskly.(Motor oils classified SE or SF will show.In temperatures below 20,OC (68O F) use the choke knob.If the choke was used, push it in gradually as the engine warms.Moving the lever farther from the F position will increase the throttle opening and the boat forward speed.Component identification stern bracket adjusting ROD anti-cavitation plate water intake gear OIL level bolt gear OIL drain bolt- propeller (bfzos).Advanced Marine Structures - Srinivasan Chandrasekaran 2016, PDF.After starting, be sure water is flowing out of the water check hole.R (reverse Moving the lever to the R position (approximately 30 from the N position) will engage the rev.